Is anyone capable of machining out small parts from 1/8 in. brass sheet? The parts are between 1/2 in and 3/4 in in dimensions. Some parts need small holes (1/32 in. diamater), or if this is not possible, small marks etched on the surface to mark the positions of the holes. If this is possible, how far apart should I position my parts? I'm looking to have a 1 ft x 1 ft square sheet milled down to start. If anyone knows anything or can help, that would be great! It has been hard to find information about miniature machining. Thanks.
Edited 2 time(s). Last edit at 04/25/2012 11:40PM by Tim Morales.